Protein Information

ID 4145
Name Ca II
Synonyms CA IX; CA1; Carbonic anhydrase I; CA2; CAII; Carbonic anhydrase II; Carbonic dehydratase; Carbonic anhydrase III…

Compound Information

ID 1393
Name chloroform
CAS trichloromethane

Reference

PubMed Abstract RScore(About this table)
18968014 Gavazov K, Simeonova Z, Alexandrov A: Extraction spectrophotometric determination of vanadium in natural waters and aluminium alloys using pyridyl azo resorcinol (PAR) and iodo-nitro-tetrazolium chloride (INT). Talanta. 2000 Jun 30;52(3):539-44.
Extraction-spectrophotometric methods are developed for the determination of vanadium content in natural waters and aluminium alloys. They are based on the formation and subsequent extraction into chloroform of the ternary ion association complex of V (V) with PAR and INT in the presence of CDTA and NH (4) F as masking agents. Optimum pH range of the reaction is 5.5-7.5. Maximum absorbance of the extracted complex is at 560 nm. The method for determination of V (V) in drinking waters can be successfully applied at a concentration level of 3 ppb and higher without additional pre-concentration. Among studied more than 30 foreign ions potentially present in natural waters only Ca (II) can interfere. It is removed by precipitation as CaF (2) and filtration. A 40-fold excess of V (IV) does not interfere with determination of V (V) and can also be determined indirectly (after oxidation to V (V)). The proposed method is applied to analysis of model mixtures as well as to the analysis of tap and mineral waters. Beer's law is obeyed for up to 15 mug of V (V) in 40 ml aqueous phase. The accuracy and precision are reasonable. The RSD is in the range 6.5-23.2% for determination of 6.3 ppb V (V). The procedure for analysis of aluminium alloys differs from the procedure for analysis of waters by the order of introduction of the reagents. The macrocomponent does not interfere and is not separated. Mg, Mn, Cu, Zn, Fe, Cr, Ti and Zr do not interfere. A 25-fold excess of Ni interferes. The method is tested in the analysis of reference standards containing 0.005 and 0.007% V, respectively. The RSD is 1.4%.
1(0,0,0,1)