| 19722630 |
Yu S, Azzam T, Rouiller I, Eisenberg A: "Breathing" vesicles. . J Am Chem Soc. 2009 Aug 5;131(30):10557-66.
A vesicle system is described that possesses a pH-induced "breathing" feature and consists of a three-layered wall structure. The "breathing" feature consists of a highly reversible vesicle volume change by a factor of ca. 7, accompanied by diffusion of species into and out of the vesicles with a relaxation time of ca. 1 min. The triblock copolymer poly (ethylene oxide)(45)-block-polystyrene (130)-block-poly (2-diethylaminoethyl methacrylate)(120) (PEO (45)-b-PS (130)-b-PDEA (120)) was synthesized via ATRP. Self-assembly into vesicles was carried out at a pH of ca.10.4. The vesicle wall was shown by cryo-TEM to consist of a sandwich of two external ca. 4 nm thick continuous PS layers and one ca. 17 nm thick PDEA layer in the middle. As the pH decreases, both the vesicle size and the thickness of all three layers increase. The increase of the thickness of the intermediate PDEA layer arises from the protonation and hydration, but the swelling is constrained by the PS layers. The increase of the thickness of the two PS layers is a result of an increasing incompatibility and an accompanying sharpening of the interface between the PS layers and the PDEA layer. Starting at a pH slightly below 6, progressive swelling of the PDEA layer with decreasing pH induces a cracking of the two PS layers and also a sharp increase of the vesicle size and the wall thickness. By pH 3.4, the vesicle size has increased by a factor of approximately 1.9 and the wall shows a cracked surface. These changes between pH 10.4 and 3.4 are highly reversible with the relaxation time of ca. 1 min and can be performed repeatedly. The change in the wall structure not only increases dramatically the wall permeability to water but also greatly expands the rate of proton diffusion from practically zero to extremely rapid. |
85(1,1,1,5) |